Concrete Patio & Driveway Cost in North Dakota (2026)
Concrete Patio & Driveway in North Dakota runs about the same as the national average. A typical 600 sq ft project starts around $3,600–$7,200 for standard broom finish. Estimate your exact project below.
North Dakota sits right around the national average on cost, though rural logistics can raise material prices in remote areas.
Reviewed by the AnyCoster Research Team · How we estimate costs
Concrete Patio & Driveway Cost Calculator
Adjust the details for an installed-cost range tailored to you.
Length × width of the slab. A 2-car driveway is ~600 sq ft.
Ballpark estimate for planning — not a quote.
Get your exact price from local concrete pros
This is a ballpark — compare up to 3 free, no-obligation quotes from vetted contractors in North Dakota.
Concrete Patio & Driveway cost in North Dakota by material
Installed cost for a typical 600 sq ft project in North Dakota.
| Material | Per sq ft | Typical ND project |
|---|---|---|
| Standard broom finish | $6.0–$12.0 | $3,600 – $7,200 |
| Stamped / colored | $12.0–$20.0 | $7,200 – $12,000 |
| Paver equivalent | $15.0–$28.0 | $9,000 – $16,800 |
What affects your North Dakota cost
- Finish (plain vs stamped/colored)
- Slab thickness and rebar/mesh reinforcement
- Site prep, grading and old-slab removal
- Access for the concrete truck
- Local labor and material prices
Concrete Patio & Driveway in North Dakota: local factors that move the price
Climate & weather
Extreme cold, deep frost, heavy snow, and strong winds dominate exterior design, so frost-protected foundations, heavy insulation, and snow-load-ready roofs are essential. The warm season is short.
Regional norms in North Dakota
Deep foundations, heavy insulation, and steep snow-shedding roofs are standard here.
Best time to schedule
Late spring through early fall is effectively the only practical window for foundation and most exterior work.
Permits & code
Permit requirements vary between cities and rural areas, with frost-depth, snow-load, and energy provisions central where codes apply.
North Dakota concrete patio & driveway — FAQ
How much does concrete patio & driveway cost in North Dakota?
In North Dakota, a typical 600 sq ft concrete patio & driveway project runs about $3,600–$7,200 for standard broom finish, installed. That's about the same as the national average. Higher-end materials cost more — use the calculator above for your exact size and material.
How much does concrete patio & driveway cost per sq ft in North Dakota?
In North Dakota, installed concrete runs about $6.0–$28.0 per sq ft depending on material (standard broom finish $6.0–$12.0, stamped / colored $12.0–$20.0, paver equivalent $15.0–$28.0). That's about the same as the national average.
Do I need a permit for concrete patio & driveway in North Dakota?
Permit requirements vary between cities and rural areas, with frost-depth, snow-load, and energy provisions central where codes apply. Always confirm requirements with your local building department, and factor permit time and inspections into your schedule.
When is the best time to do concrete patio & driveway in North Dakota?
Late spring through early fall is effectively the only practical window for foundation and most exterior work. Extreme cold, deep frost, heavy snow, and strong winds dominate exterior design, so frost-protected foundations, heavy insulation, and snow-load-ready roofs are essential. The warm season is short.
How much does a concrete driveway cost in 2026?
A standard ~600 sq ft concrete driveway runs about $3,600–$7,200 installed; stamped or colored concrete runs $7,200–$12,000. Thickness, finish and site prep drive the price — use the calculator for your area.
Is stamped concrete worth the extra cost?
Stamped concrete costs about 2× plain but mimics stone, brick or pavers at a lower price than the real thing, and is a single poured surface with fewer weeds/settling issues than pavers. Good middle ground for looks vs budget.