Concrete Patio & Driveway Cost in Georgia (2026)
Concrete Patio & Driveway in Georgia runs about 4% below the national average. A typical 600 sq ft project starts around $3,460–$6,910 for standard broom finish. Estimate your exact project below.
Georgia runs slightly below the national average on cost, with a large, active Atlanta-area labor market keeping trades reasonably available.
Reviewed by the AnyCoster Research Team · How we estimate costs
Concrete Patio & Driveway Cost Calculator
Adjust the details for an installed-cost range tailored to you.
Length × width of the slab. A 2-car driveway is ~600 sq ft.
Ballpark estimate for planning — not a quote.
Get your exact price from local concrete pros
This is a ballpark — compare up to 3 free, no-obligation quotes from vetted contractors in Georgia.
Concrete Patio & Driveway cost in Georgia by material
Installed cost for a typical 600 sq ft project in Georgia.
| Material | Per sq ft | Typical GA project |
|---|---|---|
| Standard broom finish | $5.8–$11.5 | $3,460 – $6,910 |
| Stamped / colored | $11.5–$19.2 | $6,910 – $11,520 |
| Paver equivalent | $14.4–$26.9 | $8,640 – $16,130 |
What affects your Georgia cost
- Finish (plain vs stamped/colored)
- Slab thickness and rebar/mesh reinforcement
- Site prep, grading and old-slab removal
- Access for the concrete truck
- Local labor and material prices
Concrete Patio & Driveway in Georgia: local factors that move the price
Climate & weather
Hot, humid summers and heavy rainfall favor mildew-resistant finishes and solid drainage, while the coast and southern counties carry hurricane and wind exposure. North Georgia sees more temperature swing than the coastal plain.
Regional norms in Georgia
Brick veneer and vinyl siding are common, with wind-rated materials favored nearer the coast.
Best time to schedule
Fall and spring offer the most comfortable conditions, avoiding peak summer heat and humidity.
Permits & code
Most Georgia jurisdictions require permits for structural, roofing, and electrical work, with coastal counties adding wind provisions.
Georgia concrete patio & driveway — FAQ
How much does concrete patio & driveway cost in Georgia?
In Georgia, a typical 600 sq ft concrete patio & driveway project runs about $3,460–$6,910 for standard broom finish, installed. That's about 4% below the national average. Higher-end materials cost more — use the calculator above for your exact size and material.
How much does concrete patio & driveway cost per sq ft in Georgia?
In Georgia, installed concrete runs about $5.8–$26.9 per sq ft depending on material (standard broom finish $5.8–$11.5, stamped / colored $11.5–$19.2, paver equivalent $14.4–$26.9). That's about 4% below the national average.
Do I need a permit for concrete patio & driveway in Georgia?
Most Georgia jurisdictions require permits for structural, roofing, and electrical work, with coastal counties adding wind provisions. Always confirm requirements with your local building department, and factor permit time and inspections into your schedule.
When is the best time to do concrete patio & driveway in Georgia?
Fall and spring offer the most comfortable conditions, avoiding peak summer heat and humidity. Hot, humid summers and heavy rainfall favor mildew-resistant finishes and solid drainage, while the coast and southern counties carry hurricane and wind exposure. North Georgia sees more temperature swing than the coastal plain.
How much does a concrete driveway cost in 2026?
A standard ~600 sq ft concrete driveway runs about $3,600–$7,200 installed; stamped or colored concrete runs $7,200–$12,000. Thickness, finish and site prep drive the price — use the calculator for your area.
Is stamped concrete worth the extra cost?
Stamped concrete costs about 2× plain but mimics stone, brick or pavers at a lower price than the real thing, and is a single poured surface with fewer weeds/settling issues than pavers. Good middle ground for looks vs budget.
Top cities in Georgia
Metro-level concrete patio & driveway costs — usually a bit above the Georgia state average.